Common Causes Of Wheel Rim Cracks And Failures

Nov 18, 2026 Leave a message

Cracks and early breakdown of wheel rims often happen on loaders, mining dump trucks and underground LHD machines. These problems create safety hazards and stop your work unexpectedly. From our many years of checking failed rims and site feedback, Anqiang lists the real reasons and simple ways to avoid rim damage.

1. Wrong or poor-quality steel

If the steel grade cannot handle heavy mining work, or the raw material itself has impurities, small cracks will form easily under repeated bumps. Even high-strength steel can crack in cold mines if it cannot stand low-temperature impact.

2. Overloading and constant hitting

This is the most frequent reason. When the machine carries more weight than it is designed for, or runs on rough, bumpy mine roads, sudden heavy stress hits the rim again and again. Tiny fatigue cracks start at welds, bead seats or curved parts, then keep growing until the rim breaks.

3. Bad welding work

Most wheel rims are joined by submerged arc welding. Holes, slag trapped inside, shallow welds or sharp weld edges are hidden weak points. Machine vibration makes these small flaws turn into cracks fast. Without proper stress release after welding, the risk gets higher.

4. Mistakes during fitting and daily checks

  • Wheel bolts tightened too loose or too tight: stress spreads unevenly on the rim
  • Mismatched tires, rims and lock rings: wrong gaps lead to squeezing and rubbing
  • Rare inspections: fine cracks are missed until they become big
  • Wrong tire pressure: too low pressure bends the rim; too high pressure puts heavy stress on the bead seat

5. Knocks and rust

Hitting rocks causes dents. Cracks tend to start right at the edge of these dents. In wet, muddy mines with acidic water, rust eats away the rim surface, thinning the metal and speeding up cracking.

6. Poor rim structure design

Sharp corners and too-small curved transitions create spots where stress piles up. Custom rims that skip professional strength checks are more likely to fail under tough mining conditions.

Simple tips from Anqiang to prevent rim cracks

  1. Pick suitable steel and rim design based on your actual working site, not just the machine's marked tonnage.
  2. We check every batch of incoming steel and run UT / MT tests on all key welds during production.
  3. Do not overload. Tighten bolts to the standard torque, and check rims after working on rocky ground.
  4. Avoid hitting rocks hard. Touch up the protective coating once it gets scratched.
  5. Stop using the rim right away if you spot cracks. Never keep running with a cracked rim.

Our technical team can examine your broken rims and work out better material and structure plans to cut down crack risks for mining and construction machinery.